Viðgerðasett fyrir framrúðu

Settið inniheldur:

Sérstakt plastefni – 2 ml
Uppsetningarstand
4 herðingarþynnur
1 rakblað til að fjarlægja umfram plastefni
1 par af einnota hönskum

How to use:

Prepare the repair area – clean and degrease.
Remove chips using a pin and place it in the syringe opening.
Adhere the seal to the glass.
Adhere the applicator to the seal, pressing firmly to ensure a tight seal.
Place the resin tube in the applicator and slowly squeeze the resin into the glass.
Insert the syringe into the applicator, press the trigger to remove air bubbles from the adhesive, and leave it for 10 minutes.
Remove the pin from the bottom of the syringe, then reinsert it.
Press the syringe trigger to build up pressure, lock the trigger, and leave it for 20 minutes.
Use a blade to gently remove the applicator tip, the seal, and any protruding resin.
Apply the hardening film to the surface, lift its edge, and press a drop of resin. Apply the film to the repaired area.
Remove air bubbles by sliding the blade over the film.
Park the car in a sunny location. Leave the sunlight to harden the resin – this may take about 60 minutes.
Remove the foil and clean any uneven surfaces.